Kyocera FS FS-1020D - Cassette Mode; Expansion Memory

Glossary
Glossary-2
Cassette mode
This is an operation mode for the MP tray. When
this mode is used, approximately 50 sheets of
plain paper can be fed continuously, the same as
for the cassette.
dpi (dots per inch)
This indicates the number of dots printed per
inch, and is the unit of printer resolution.
EcoPrint
This is a printing mode that controls toner
consumption. Pages printed in the EcoPrint
mode are lighter than pages printed in the
normal mode. The default setting is Off.
Emulation
This refers to emulation of manufacturers’
printers. The printer emulates operation of the
following printers: PCL, Line printer, IBM
Proprinter, DIABLO 630, EPSON LQ-850,
KPDL.
Expansion memory
This option is used to increase printer memory.
The printer has one expansion slot, and you can
install a 8 MB, 16 MB, 32 MB, 64 MB, 128 MB,
or 256 MB DIMM (Dual Inline Memory Module).
Contact your Kyocera Mita dealer to purchase
the DIMM that is best suited for use with this
printer.
First mode
This is an operation mode for the MP tray.
Because the MP tray default setting is set to first
mode (priority printing from the MP tray), if
there is paper inserted in the MP tray, the first
paper will always feed from there even if another
paper source is selected. First mode is specified
as the factory default, but you can change this
setting from the KM-NET for Clients.
IEEE1284
This is a standard used when connecting a
printer to a computer, and was established by the
Institute of Electrical and Electronic Engineers
in 1994.
KIR (Kyocera Image Refinement)
This is Kyocera Mita’s original smoothing
function. It uses software to enhance the
printer’s resolution and produce high-quality
printing. The default setting is On.
KM-NET for Clients
This is a utility that displays a virtual printer
operation panel on your computer screen. You
can make various settings from the KM-NET for
Clients, such as the current paper source and
paper size. The KM-NET for Clients is contained
on the Kyocera Mita Software Library CD-ROM
supplied with the printer.
KM-NET VIEWER
This is a network management tool that can be
used with the printer. You can view information
for printers connected to the network using
SNMP commands. KM-NET VIEWER is contained
on the Kyocera Mita Software Library CD-ROM
supplied with the printer.
KPDL
(Kyocera Printer Description
Language)
This is Kyocera Mita’s version of Adobe
PostScript 3.
MB (mega byte)
This unit is used to express data quantities and
memory capacities. 1 MB is equivalent to
1024 KB, or 1,048,576 bytes.