Kyocera KM-1820

Printing Basics
User Guide 3-6
2
Select the Print on both sides (manual duplex) check box. 2
3
Select Flip on Long Edge or Flip on Short Edge. 3
4
Select Print manual duplex instructions to print an instruction sheet. Follow the
printed instructions for placing the pages back into the cassette after the first side is
printed. 4
- OR -
Clear Print manual duplex instructions and follow steps 5-7.
5
Click OK in the Properties dialog box and Print dialog box. 5
The even-numbered pages will be printed.
6
When printing stops, remove all printed sheets from the output tray. 6
With Flip on Long Edge selected, turn the stack over on the long edge and put the
pages into the cassette.
With Flip on Short Edge selected, turn the stack over on the short edge and put the
pages into the cassette.
7
Click OK in the Manual Duplex Instruction dialog box. 7
The odd-numbered pages will be printed.
Collate
Collate enables the driver to internally assemble print job pages in numerical
sequence. It increases print speed to specify the printed page order of a multi-copy
job. 8
•With Collate selected, the driver prints the job, set by set. All the pages of the
first set are printed, followed by all pages of the next set. For example: For
printing two sets of a three page document, the default page ordering would be
1, 2, 3, 1, 2, 3.
•With Collate cleared, the first page is printed for all sets, followed by the next
page for all sets. For example: For printing two sets of a three page document,
the default page ordering would be 1, 1, 2, 2, 3, 3.
The driver graphics image displays the grouping of collating and non-collating.
The printer driver automatically overrides the application's collate setting and uses
the printer driver setting. To use the Basic > Collate option, clear the Device
Settings > Compatibility > Ignore application collation check box. 9