Kyocera KM-1820

Layout
4-3 KX Driver
• Overlap edges
Select this option to duplicate the edges of document data on adjoining sheets.
Poster appearance is improved when the edges overlap slightly. Select the
check box, then type or select a value between 0.00 and 1.20 inches (0.0 and
30.4 mm). This option reduces the final poster size slightly.
• Print crop marks
Select this option to print a border at the edges of each poster sheet. You can
crop each sheet on the border before assembling the sheets. This option
ensures that data on adjoining sheets matches precisely.
• Print assembly marks
Select this option to print numbers at the edges of each sheet, matching
numbers on adjoining sheets. Assemble each sheet edge to the same numbered
edge on another sheet. For a large poster with many sheets, this option ensures
that the poster assembles correctly.
Scaling
Based on the page size and print size specified in the Basic tab, you can reduce or
enlarge the image from 20% to 500% of the original size.
Click the Layout tab in the Properties dialog box, and type the scale percentage into
the Scaling (20-500%) box, or click the up or down arrow buttons to adjust the value.
Gutter
Based on the page size and print size specified in the Basic tab, you can increase
the top and/or left margin.
Click Gutter to increase the outside margins in a range from 5.0 to 25.4 mm (0.20 to
1.00 inch). The left and/or top margins can be adjusted.
• To increase outside margins on the left side of the page, enter a number into the
Left (long edge) box. This option may not be available, depending on your
Orientation and Print on both sides settings in the Basic tab.
• To increase outside margins at the top of the page, enter a number into the Top
(long edge) box. This option may not be available, depending on your
Orientation and Print on both sides settings in the Basic tab.
•Since the Gutter feature shifts document data to the right or down, select the
Reduce image to fit check box if the printed data extends beyond the edge of
the paper when changing the gutter setting. The size of the printed data is
decreased slightly to fit in the printable margins of the page.
• If the document data is small enough that it does not extend beyond the edge of
the paper when the gutter is increased, clear the Reduce image to fit check
box.
If you want to change the page size, refer to Print Sizes on page 3-2.