Section 3 PREPARATIONS
3-6
3
Keeping the flap closed, situate envelopes with the print
side face-up and the flap side towards the front of the copier
or towards the leading edge of insertion. Then slide them
all the way into the multi-bypass tray, along the insert
guides, as far as they will go.
NOTES
• The proper orientation will actually depend upon the
type of envelope being used.
• Make sure that the flaps of all the envelopes are closed
before inserting them into the multi-bypass tray. Make
sure all envelopes are folded well at each crease so they
lay flat on the by-pass tray.
• DO NOT set the flap towards the trailing edge of
insertion as there is a danger of it jamming.
• When setting envelopes on the multi-bypass tray, BE
SURE to specify the type of envelopes that will be used
under “Multi-bypass tray paper settings” on
page 7-99.
Copier
Copier
Copier
To Next Page
Loading...
