2LK/2LN/2LM/2LC-2
1-3-34
U033 Checking the operation of the solenoids
Description
Turns each solenoid on.
Purpose
To check the operation of each solenoid.
Method
1. Press the start key.
2. Select the solenoid to be operated.z
3. Press the start key. The operation starts.
*: 45 ppm/55 ppm model only.
4. To stop operation, press the stop key.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
U034 Adjusting the print start timing
Description
Adjusts the leading edge registration or center line.
Purpose
Make the adjustment if there is a regular error between the leading edges of the copy image and
original.
Make the adjustment if there is a regular error between the center lines of the copy image and
original.
Method
1. Press the start key.
2. Select the item to be adjusted.
*: 55 ppm model only.
Item No. Description
Display Description
Branch Exit Feedshift solenoid (FSSOL) is turned on
Pick Up1* Pickup solenoid 1,2 (PUSOL1,2) is turned on
Job Separator JS feedshift solenoid (JSFSSOL) is turned on
ID Clean Cleaning solenoid (CLSOL) is turned on
Motor Paper feed motor (PFM) is turned on
Display Description
LSU Out Top Leading edge registration adjustment
LSU Out Left Center line adjustment
LSU Out Top B/W* Leading edge registration adjustment in black/white mode
LSU Out Top 3/4 Leading edge registration adjustment at 3/4 times of line speed
To Next Page
Loading...
