2LK/2LN/2LM/2LC-2
1-5-89
(8) Detaching and refitting the eject unit
Procedure
1. Remove the right upper cover (see
page 1-5-66).
2. Remove the fuser unit (see page 1-5-
45).
3. Remove the connector.
4. Remove two screws and then remove
the eject unit.
5. Check or replace the eject unit and refit
all the removed parts.
Figure 1-5-143
Cautions on installing the eject unit
When inserting the eject unit into the device,
use care that the eject unit does not get in con-
tact with the eject guide, by keeping its actua-
tor lifted while inserting.
Figure 1-5-144
Eject unit
Connector
Screw
Screw
Actuator
Eject guide
To Next Page
Loading...
