2LK/2LN/2LM/2LC-2
1-2-68
1-2-8 Installing the gigabit ethernet board (option)
Procedure
1. Press the power key on the operation
panel to off. Make sure that the power
indicator and the memory indicator are
off before turning off the main power
switch. And then unplug the power
cable from the wall outlet.
2. Open the controller lid.
3. Remove two pins and then slot cover of
the OPT2.
Figure 1-2-90
4. Insert the gigabit ethernet board along
the groove in OPT2 and secure the
board with two pins that have been
removed in step 3.
*: Do not directly touch the gigabit ethernet
board terminal.
Hold the top and bottom of the gigabit
ethernet board, or the projection of the
board to insert the gigabit ethernet board.
Figure 1-2-91
Slot cove
Pin
Pin
Controller lid
OPT2
Groove
Pin
Pin
Gigabit
ethernet board
To Next Page
Loading...
