Kyocera TASKalfa 3050ci - (11) The leading edge of the image is consistently misaligned with the original.; (12) The leading edge of the image is sporadically misaligned with the original.; (13) Paper is wrinkled.

2LK/2LN/2LM/2LC
1-4-98
(11) The leading edge of the image is consistently misaligned with the original.
(12) The leading edge of the image is sporadically misaligned with the original.
(13) Paper is wrinkled.
Print example Causes Check procedures/corrective measures
Misadjusted leading edge reg-
istration.
Run maintenance mode U034 to readjust the leading edge
registration (see page 1-3-34).
Misadjusted the deflection in
the paper.
Run maintenance mode U051 to readjust the deflection in
the paper (see page 1-3-41).
Misadjusted scanner leading
edge registration.
Run maintenance mode U066 to readjust the scanner
leading edge registration (see page 1-3-54).
Print example Causes Check procedures/corrective measures
Paper feed clutch, middle
clutch, registration clutch or
duplex clutch operating incor-
rectly. (30 ppm model/35 ppm
model)
Check the installation of the clutch. If it operates incor-
rectly, replace it.
Paper feed clutch, middle
motor, registration motor or
duplex motor operating incor-
rectly. (45 ppm model/55 ppm
model)
Check the installation of the clutch or motor. If it operates
incorrectly, replace it.
Print example Causes Check procedures/corrective measures
Paper curled. Check the paper storage conditions.
Paper damp. Check the paper storage conditions.
Defective pressure springs. Replace the fuser unit (see page 1-5-45).