Kyocera TASKalfa 3050ci - (8) One side of the print image is darker than the other.; (9) Spots are printed.; (10) Image is blurred.

2LK/2LN/2LM/2LC
1-4-97
(8) One side of the print image is darker than the other.
(9) Spots are printed.
(10) Image is blurred.
Print example Causes Check procedures/corrective measures
Defective exposure lamp.
Replace the LED unit (see page 1-5-19).
Print example Causes Check procedures/corrective measures
Dirty contact glass. Clean the contact glass.
Dirty or flawed drum. Perform the drum refresh.
Flawed drum. Replace the drum unit (see page 1-5-36).
Deformed or worn cleaning
blade in the drum unit.
Replace the drum unit (see page 1-5-36).
Flawed developer roller. Replace the developer unit (see page 1-5-36).
Dirty heat roller and press
roller.
Clean the heat roller and press roller.
Print example Causes Check procedures/corrective measures
Scanner moves erratically. Check if there is any foreign matter on the front and rear
scanner rails. If any, remove it.
Deformed press roller. Replace the fuser unit (see page 1-5-45).
Paper conveying section drive
problem.
Check the gears and belts and, if necessary, grease them.