Kyocera TASKalfa 3050ci - Page 388

2LK/2LN/2LM/2LC-2
1-4-90
9130 Sensor error in coin vender
change (Yen 50)
Change is empty despite
change is enough.
Coin jam in the
change tube
Check visually and remedy.
Poor contact in the
connector.
Check if the change empty sensor is intact.
Defective change
empty sensor.
Replace the coin mec.
Defective coin
vender control
PWB.
Replace the coin mec.
9140 Sensor error in coin vender
change (Yen 100)
Change is empty despite
change is enough.
Coin jam in the
change tube
Check visually and remedy.
Poor contact in the
connector.
Check if the change empty sensor is intact.
Defective change
empty sensor.
Replace the coin mec.
Defective coin
vender control
PWB.
Replace the coin mec.
9150 Sensor error in coin vender
change (Yen 500)
Change is empty despite
change is enough.
Coin jam in the
change tube
Check visually and remedy.
Poor contact in the
connector.
Check if the change empty sensor is intact.
Defective change
empty sensor.
Replace the coin mec.
Defective coin
vender control
PWB.
Replace the coin mec.
9160 Coin vender pay-out error
Coin is paid out despite the
pay-out motor is determined
not active.
Defective pay-out
motor.
Replace the coin mec.
9170 Coin vender pay-out sensor
error
Coin is paid out despite the
pay-out motor is determined
not active.
Change jam at the
pay-out.
Check visually and remedy.
Defective pay-out
motor.
Replace the coin mec.
Defective pay-out
sensor.
Replace the coin mec.
9500 Contact the Service Administrative Division.
9510 Contact the Service Administrative Division.
9520 Contact the Service Administrative Division.
9530 Contact the Service Administrative Division.
9540 Contact the Service Administrative Division.
9550 Contact the Service Administrative Division.
Code Contents Causes
Check procedures/
corrective measures