2LK/2LN/2LM/2LC
1-5-12
5. Remove two connectors.
6. Release the wire saddle.
7. Remove the wire saddle.
*: To refit the wire saddle, be sure to fit in
the positioning hole that was previously
used.
Figure 1-5-19
8. Remove the MP tray.
*: When refitting the MP tray, insert it in
the MP tray paper feed unit side by
turning the lift arm.
Figure 1-5-20
Installation
hole
Connector
Connector
Wire
saddle
Wire
saddle
MP tray
Lift arm
MP tray
MP tray paper feed unit
To Next Page
Loading...
