2LK/2LN/2LM/2LC
1-5-21
7. Move the LED mount assembly to the
cutting lack part.
8. Unhook the hook and remove the FFC
cover from LED mount assembly.
9. Remove the FFC from the FFC connec-
tor.
10. Unhook two hooks and remove the FFC
guide from the LED mount assembly.
Figure 1-5-35
11. Remove two screws and then remove
the LED mount assembly.
12. Check or replace the LED mount
assembly and refit all the removed
parts.
*: When cleaning the reflector, the light
guiding plate and the diffusion sheet of
the LED mount assembly, clean it by air
blow. Not to leave the hair dust.
13. When the LED mount assembly is
replaced, perform maintenance mode
U411 (Adjusting the scanner automati-
cally) (see page 1-3-157).
Figure 1-5-36
FFC guide
Hook
Hook
Hook
FFC cover
LED mount assembly
LED mount assembly
Cutting lack part
Cutting lack part
FFC connector
FFC
Screw
Screw
LED mount assembly
To Next Page
Loading...
