2LK/2LN/2LM/2LC
1-5-76
8. Remove the connector.
9. Remove three screws.
10. Remove the fuser drive unit.
Figure 1-5-125
Detaching the transfer drive unit
11. Pull out the transfer belt unit a little (see
page 1-5-41).
12. Release the clamp.
13. Remove the connector.
14. Remove three screws.
15. Remove the transfer drive unit.
Figure 1-5-126
Fuser drive unit
Fuser drive unit
Connector
Screw
Screw
Screw
Transfer drive unit
Connector
Clamp
Clamp
Screw
Screws
Connector
[30ppm/35ppm][45ppm/55ppm]
Screw
Transfer drive unit
Screws
Transfer drive unit
To Next Page
Loading...
