Kyocera TASKalfa 3050ci - Page 582

2LK/2LN/2LM/2LC-2
2-3-32
YC20
27 BRIDGE1 CLK O 0/3.3 V DC (pulse) BRCM1 clock signal
Connected to
bridge unit
28 BRIDGE1 PD O 0/3.3 V DC BRCM1 control signal
29 BRIDGE1 DIR O 0/3.3 V DC BRCM1 drive switch signal
30 BRIDGE_SENS 2 I 0/3.3 V DC BRCS2: On/Off
31 BRIDGE_OPEN I 0/3.3 V DC BRCSW: On/Off
32 BRIDGE_SENS 1 I 0/3.3 V DC BRCS1: On/Off
33 GND - - Ground
34 5V O 5 V DC 5 V DC power to BRPWB
35 GND - - Ground
36 GND - - Ground
37 +24V1 O 24 V DC 24 V DC power to BRPWB
38 +24V1 O 24 V DC 24 V DC power to BRPWB
YC22
1 LVU_FAN O 0/24 V DC PSFM: On/Off
Connected to
power source
fan motor
2 +24V1 O 24 V DC 24 V DC power to PSFM
YC23
1 +24V O 24 V DC 24 V DC power to coin vender
Connected to
coin vender
2 GND - - Ground
3 GND - - Ground
4 COIN_EN I 0/3.3 V DC Coin vender enable signal
5FGND -- Ground
6 FEED_COUNT O 0/3.3 V DC Coin vender control signal
7 EJECT_COUNT O 0/3.3 V DC Coin vender control signal
8 COPYING_SIG O 0/3.3 V DC Coin vender control signal
9 TXD_COIN O 0/3.3 V DC (pulse) Serial communication data signal
10 GND - - Serial communication data signal
11 RXD_COIN I 0/3.3 V DC (pulse) MCL: On/Off
12 GND - - Ground
YC24
1 GND - - Ground
Connected to
key counter
2 DC1_SET I 0/3.3 V DC Key counter set signal
3 DC1_COUNT O 0/3.3 V DC Key counter count signal
4 +24V 1 O 24 V DC 24 V DC power to key card
Connector Pin Signal I/O Voltage Description