Kyocera TASKalfa 3050ci - Page 627

2LK/2LN/2LM/2LC-2
2-3-77
YC1
35 PICK_SOL1_RET I 0/24 V DC PUSOL1: On/Off (RET)
Connected to
engine PWB
36 PICK_SOL1_REM I 0/24 V DC PUSOL1: On/Off (ACT)
37 CAS2_P0 O 0/3.3 V DC FS2: On/Off
38 CAS2_LIFT_UP O 0/3.3 V DC LS2: On/Off
39 CAS2_EMPTY O 0/3.3 V DC PS2: On/Off
40 PICK_SOL2_RET I 0/24 V DC PUSOL2: On/Off (RET)
41 PICK_SOL2_REM I 0/24 V DC PUSOL2: On/Off (ACT)
42 GND - - Ground
43 REG_SENS O 0/3.3 V DC RS: On/Off
44 FEED1_SENS O 0/3.3 V DC PCS: On/Off
45 BEND_SENS O 0/3.3 V DC RDS: On/Off
46 MID_MOT_PH I 0/3.3 V DC MM control signal
47 MID_MOT_REM(
ROL_CL)
I 0/3.3 V DC MM/MCL: On/Off
48 MID_MOT_CLK I 0/3.3 V DC (pulse) MM clock signal
49 MID_MOT_PD I 0/3.3 V DC MM control signal
50 ASIST_CL1 I 0/24 V DC ASCL1: On/Off
YC2
1FEED_MOT_GAI
N
- - Not used
Connected to
paper feed
motor
2 FEED_MOT_DIR O 0/3.3 V DC PFM drive switch signal
3 FEED_MOT_RDY I 0/3.3 V DC PFM ready signal
4 FEED_MOT_CLK O 0/3.3 V DC (pulse) PFM clock signal
5 FEED_MOT_REM O 0/24 V DC PFM: On/Off
6 GND - - Ground
7 24V2 O 24 V DC 24 V DC power to PFM
YC3
1 CAS1_LNG1 I 0/3.3 V DC PLSW1: On/Off
Connected to
paper length
switch 1/2,
paper width
switch 1/2, lift
motor 1/2,
paper gauge
sensor 1(U)/
(L) and paper
gauge sen-
sor 2(U)/(L)
2 CAS1_LNG2 I 0/3.3 V DC PLSW1: On/Off
3 GND - - Ground
4 CAS1_LNG3 I 0/3.3 V DC PLSW1: On/Off
5 CAS1_WID I 0/3.3 V DC PWSW1: On/Off
6 GND - - Ground
7 CAS2_LNG1 I 0/3.3 V DC PLSW2: On/Off
8 CAS2_LNG2 I 0/3.3 V DC PLSW2: On/Off
9 GND - - Ground
10 CAS2_LNG3 I 0/3.3 V DC PLSW2: On/Off
11 CAS2_WID I 0/3.3 V DC PWSW2: On/Off
12 GND - - Ground
Connector Pin Signal I/O Voltage Description