Kyocera TASKalfa 3050ci - Page 649

2LK/2LN/2LM/2LC
2-3-99
YC10
25 DATA_1N_C(LVD
S)
O 0/3.3 V DC (pulse) Video data signal C (N)
Connected to
APC PWB C
26 DATA_1P_C(LVD
S)
O 0/3.3 V DC (pulse) Video data signal C (P)
27 SGND - - Ground
28 DATA_2N_C(LVD
S)
O 0/3.3 V DC (pulse) Video data signal C (N)
29 DATA_2P_C(LVD
S)
O 0/3.3 V DC (pulse) Video data signal C (P)
30 SGND - - Ground
YC11
1 24V O 24 V DC 24 V DC power to PM-Y
Connected to
polygon
motor Y
2PGND -- Ground
3 REM Y O 0/24 V DC PM-Y: On/Off
4 LOCK Y I 0/3.3 V DC PM-Y lock signal
5 CLK Y O 0/3.3 V DC (pulse) PM-Y clock signal
YC12
1SGND -- Ground
Connected to
APC PWB Y
2 BD Y I 0/3.3 V DC (pulse) Horizontal synchronization signal Y
3 LSU_TH Y I Analog LSU thermistor Y detection signal
4 - - - Not used
5 - - - Not used
6 5V O 5 V DC 5 V DC power to APCPWB-Y
7 5V O 5 V DC 5 V DC power to APCPWB-Y
8 5V O 5 V DC 5 V DC power to APCPWB-Y
9 LDD_CS 1 Y O 0/3.3 V DC APCPWB-Y control signal
10 SDI1 I 0/3.3 V DC (pulse) Serial communication data signal
11 SDO1 O 0/3.3 V DC (pulse) Serial communication data signal
12 CLK1 O 0/3.3 V DC (pulse) APCPWB-Y clock signal
13 EEPROM CS Y I/O 0/3.3 V DC (pulse) APCPWB-Y EEPROM data signal
14 MSET_N O 0/3.3 V DC APCPWB-Y control signal
15 CUALM Y I 0/3.3 V DC APCPWB-Y alarm signal
16 - O 0/3.3 V DC APCPWB-Y control signal
17 INT_ST 1 Y O 0/3.3 V DC APCPWB-Y control signal
18 PALA_SIG P0 Y O 0/3.3 V DC APCPWB-Y control signal
19 PALA_SIG P1 Y O 0/3.3 V DC APCPWB-Y control signal
20 PALA_SIG P2 Y O 0/3.3 V DC APCPWB-Y control signal
21 PALA_SIG P3 Y O 0/3.3 V DC APCPWB-Y control signal
22 PALA_SIG P4 Y O 0/3.3 V DC APCPWB-Y control signal
23 SDCLK Y O 0/3.3 V DC (pulse) APCPWB-Y clock signal
Connector Pin Signal I/O Voltage Description