Kyocera TASKalfa 3050ci - Page 85

2LK/2LN/2LM/2LC-2
1-2-61
6. Remove two screws and then remove
the lid.
Figure 1-2-80
7. Connect the connector of the vender
signal cable to the connector YC23 on
the engine PWB.
8. Pass the vender signal cable through
the wire guide and ten wire saddles and
then fasten the cable.
Figure 1-2-81
Screws
Lid
YC23
Wire
saddles
Vender
signal cable
Engine PWB
Wire saddles
Wire
saddle
Wire saddles
Wire saddle
Wire guide