2LK/2LN/2LM/2LC-2
1-2-63
15. Fit the ferrite core to signal cable of coin
vender.
16. Fit the clamp to signal cable of coin
vender.
17. Remove a screw from the coin vender
and fix the coin vender with a clamp.
Figure 1-2-84
18. Affix the price size decal at the right
side of the coin vender operation panel.
Figure 1-2-85
19. Turn the main power switch on and
enter the maintenance mode.
20. Run maintenance mode U206 and acti-
vate 'Coin vender is installed.ā Continue
configuring the coin vender required
(see page 1-3-111).
21. Exit the maintenance mode.
Screw
Clamp
Ferrite core
Signal cable
of coin vender
Signal cable of
coin vender
Coin vender
Price size seal
To Next Page
Loading...
