5-34
Operation on the Machine > WSD Scan
2
Install the driver.
Right-click the machine's icon and then click [Install].
During the installation, double-click the icon shown on the task bar to display the "Driver
Software Installation" screen. When "Your devices are ready to use" is displayed on the
[Driver Software Installation] screen, the installation is completed.
Executing WSD scan
1
[Home] ( ) key > [Send]
2
Place the originals.
3
Display the screen.
Select [WSD Scan/DSM Scan].
If DSM Scan is set to [Off] in the network settings, select [WSD Scan] and go to step 4.
4
Scan the originals.
Procedure using this machine
1 [From Operation Panel] > [Next]
2 Select the destination computer > [OK]
Select [Reload] to reload the computer list.
You can view information on the selected computer by selecting [Detail].
3 Set the type of original, file format, etc., as desired.
4 Press the [Start] key.
Sending begins and the software installed on the computer is activated.
Procedure from Your Computer
1 [From Computer] > [Start]
2 Use the software installed on the computer to send the images.
If the "User Account Control" window appears, click [Continue].
If the "Found New Hardware" window appears, click [Cancel].
Loading Originals (page 5-2)
DSM Scan (page 8-61)
To Next Page
Loading...
