6-29
Using Various Functions > Functions
Punch
Punches holes in sets of finished documents.
• This function requires the optional Document Finisher and Punch Unit.
• For details on paper sizes that can be punched, refer to the following:
Punch Unit (For 4,000-sheet/100-sheet Staple Finisher)
(page 11-26)
• The inch model provides two-hole and three-hole punching. The metric model provides two-hole and four-hole
punching.
Item Value Description
Punch Off
2 holes Left Select the position of punch holes. For details on original
orientation and position of punch holes, refer to the
following:
Original Orientation and Punch Hole Position (page
6-30)
2 holes Top
2 holes Right
3 holes Left
3 holes Top
3 holes Right
4 holes Left
4 holes Top
4 holes Right
Original
Orientation
Top Edge on Top, Top Edge on Left,
Auto
Select the orientation of the original document top edge
to scan correct direction. Select [Original Orientation]
to choose orientation of the originals, either [Top Edge
on Top] or [Top Edge on Left]. Then select [OK].
To Next Page
Loading...
