28
Remove the tablet from the docking station and note the buttons on
the same end the charge wire is attached.
1. Is for microphone.
2. Power button-ON/OFF.
3. Headphone jack.
4. Micro USB.
5. Is for charge line to the tablet.
6. Volume control.
There is also a RESET button on the side.
1, Power ON the tablet, hold button for 2-3 seconds.
2. To enter or exit the sleep mode, press and release the power
button.
3. To power OFF tablet, press and hold the power button until a
utility screen appears.
4. Select “power off”.
5. Press “OK” when confirmation box displays: “Your tablet will shut
Down”.
NOTE: DO NOT complete the steps to “Factory Reset” in your tablet
settings. This will erase all data on your tablet and VOID the
warranty on the tablet.
DOCKING STATION is where your tablet is placed to be charged
up. To connect the tablet, open the door and slide the tablet into the
sleeve about 3/4 way. Then connect the charge wire to the tablet.
Slide tablet on in and close door.
General Detector Information
As you are confined in a RV which is much smaller than a standard
house, you must realize safety detectors will be activated much
sooner than in a residential house, due to there being much less air
volume.
Three safety detectors have been placed inside of your RV. for your
safety and protection, fire extinguisher, propane/co detector and
smoke alarm.
TEST SAFETY ALARM OPERATION AFTER VEHICLE HAS
BEEN IN STORAGE, BEFORE EACH TRIP, AND AT LEAST
ONCE PER WEEK DURING USE.
SAFETY DETECTORS—3 Total-see continuing
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...
