EasyManua.ls Logo

KZ Venom - CO Alarm; Propane Gas Alarm; Malfunction;Service Signal

KZ Venom
98 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
30
Brownout Protection– The unit can tolerate short power
interruptions and brownouts where the circuit voltage drops as low
as 1 VDC. If the brownout lasts too long the unit will reset and
operate as described above.
LOW POWER OPERATION
This alarm will operate normally down to 7 VDC. Do not operate this
alarm below 7 VDC.
VISUAL AND AUDIBLE ALARM SIGNALS
This SAFE-ALERT™CO/Propane Gas Alarm is designed to be easy
to operate. The alarm has two indicator lights that display a specific
color for each monitored condition. There also is a matching sound
pattern for alarm conditions.
CO ALARM
The Red CO LED will flash and the alarm will sound 4 BEEPS then
silent for 5 seconds. These signals indicates that the CO level is over
35 ppm. IMMEDIATE ACTION IS REQUIRED. See Procedures To
Take During An Alarm. This cycle will continue until the TEST/
Mute button on the front of the alarm is pressed. Ventilate the RV.
The RED light will stay ON until the CO has cleared, or the alarm will
reactivate in approximately 6 minutes if the CO is still present. DO
NOT RE-ENTER THE RV. This alarm will return to normal operation
after the RV’s properly ventilated.
PROPANE GAS ALARM
The RED LED will flash and the alarm will sound a steady tone
whenever a dangerous level of propane or methane gas is detected.
IMMEDIATE ACTION IS REQUIRED. See Procedures To Take
During A Gas Alarm. The detector will continue to alarm until
the Test/Mute switch on the front of the alarm is pressed. Ventilate
the RV. The RED Gas LED will continue to flash until the gas has
cleared, or the gas alarm will reactivate in approximately 5 minutes if
the gas is still present. DO NOT RE-ENTER THE RV. This alarm will
return to normal operation after the RV is properly ventilated.
MALFUNCTION/SERVICE SIGNAL If any malfunction is
detected, the Gas LED will remain off and the Operational/CO LED
will alternate Red/Green and the alarm will sound once every 15
seconds. Press the Test/Mute button. If the Test/Mute button does
PDF created with pdfFactory trial version www.pdffactory.com

Table of Contents

Related product manuals