83
Oven Burner
Note: Before the oven burner will operate, the oven pilot must be lit.
1. Lighting Oven Pilot
a. Be sure ALL valves are in the “OFF” position. The oven
control knob should be the “Off” position.
b. Be sure main gas supply is on.
c. Open the oven door, smell for gas. If you smell gas STOP!
Read and follow the instructions in your appliance manual.
d. If you do not smell gas, depress and turn the oven control
knob to “Pilot On”. This will allow gas to the oven pilot.
e. Immediately light oven pilot with a match or hand held
lighter. A small flame will be noted at the top of the pilot
burner. NOTE: If the appliance has not been operated for a
long period of time, a longer waiting period for ignition of the
pilot may be necessary due to air in the gas line.
2. Operation of Oven Burner
a. Depress and turn the oven control knob counter-clockwise
to the desired setting. There may be a delay of
approximately 5 to 7 seconds before the oven burner
comes on. This is normal and no propane escapes during
this delay. It is also normal for the oven burner flame to
cycle off at all temperature settings except “Broil. This
maintains a constant temperature within the oven.
3. To shut down the oven burner turn the oven control knob
clockwise to “PILOT ON” position. At this position, the oven pilot
will remain lit.
If the user of this appliance fails to maintain it in the condition in which it
was shipped from the factory or if the appliance is not used solely for its
intended purpose or if the appliance is not maintained in accordance with
the instructions in this manual then the risk of a fire and/or the production
of carbon monoxide exists which can cause personal injury, property dam-
WARNING
!
If you do not follow these instructions exactly, a fire or explosion may result
WARNING
!
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...
