64
To remove the propane containers for refilling:
1. Remove the bottle covers (if used).
2. Close the main valve on the container.
3. Remove the two hoses at the OPD /ACME connection.
4. Install the rubber cap over the valve connection (if equipped).
5. Remove /loosen the wing nut holding the clamp hook.
6. Remove the clamp hook.
7. Fill the bottle and reverse the procedure to install. Test all
connections for leakage.
Your vehicle has exterior combustion air inlets. Appliance pilot lights should be
turned off during gasoline or propane refueling. (Required by law in some states.)
WARNING
!
1. Knob to open and close main valve.
2. Complete valve assembly.
3. “10% valve“, (small brass knob or
slot screw).
4. Container mounting stand.
ALL GAS LINES HAVE BEEN
CHECKED WITH AIR PRESSURE.
DEALERS ARE REQUIRED TO
RECHECK BEFORE DELIVERY
TO RETAIL CUSTOMERS.
THIS GAS PIPING SYSTEM IS DESIGNED FOR USE WITH PROPANE ONLY.
DO NOT CONNECT NATURAL GAS TO THIS SYSTEM.
Securely cap inlet when not connected for use. After turning on gas, except
after normal cylinder replacement, test gas piping and connections to
appliances for leakage with soapy water or bubble solution. Do not use
products that contain ammonia or chlorine.
CAUTION
!
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...
