L-Acoustics 8XT - Installation; Rigging the 8 XT or 108 P Enclosure with the ETR8-2; Assembling

XT COAXIAL RANGE - P SELF-POWERED COAXIAL RANGE
Rigging Procedures
VERSION 1
XTP_RM_ML_1
www.l-acoustics.com
12 en
6 INSTALLATION
6.1 Rigging the 8XT or 108P enclosure with the ETR8-2
6.1.1 Assembling
The ETR8-2 U-bracket is secured to the 8XT or 108P enclosure in the following way:
1. Remove the recessed set screw located on the top face of the enclosure.
Note: Put the screw in a safe place.
Figure 7: Recessed set screw
2. Remove the locking pin from the U-bracket and open the pivoting arm.
Figure 8: Opening the pivoting arm
Recessed set
scre
w