13
MAINTENANCE
HOPPER CLEANING PROCEDURE
(cont’d)
• Press and hold the yellow button on
the console to retract the packer to
its home position.
• Close the tailgate, turn off the
engine, and put the safety pins back
into place.
• Close the hopper roof gate.
DANGER
NEVER CLOSE THE HOPPER
DOOR BEHIND YOU WHILE YOU
ARE INSIDE THE HOPPER AREA.
1.1.9A BODY HOISTING
Some units are equippes with a body hoisting
system to facilitate the maintenance under
the body.
If your unit is equipped with this system,
perform the following steps to lift the body:
BODY HOISTING PROCEDURE
A. Unscrew the nuts of the 4 bolts (2
on each side) that retain the body in
place.
B. Make sure to remove all hoses from
their supports and clamps before
lifting the body in order to avoid any
damages to the hoses. The clamps
and supports are located under the
body, near the center.
C. Use the pump lever to lift the body.
D. Unlock the body safety props by
pulling the props locking pin.
E. Put body safety props in place.
DANGER
ALWAYS USE THE SAFETY
PROPS WHEN RAISING THE
BODY. FAILURE TO DO SO WILL
RESULT IN SERIOUS INJURIES
OR EVEN DEATH.
BOLTS THAT
RETAIN THE
BODY
HOSE CLAMPS
A
B
To Next Page
Loading...
