Labrie Optimizer - Page 40

OPTIMIZER
TM
40
2.0
4.0
* Replace return filter after the first 50 hours of operation
Cleaning of hopper area
3.0 Perform a visual
inspection of the following components:
Body and chassis
1.0
Hydraulic system
COMPONENT/SYSTEM
OPTIMIZER
PREVENTIVE MAINTENANCE CHART
MAINTENANCE
MANUAL
SECTION
SERVICE/CHECK
YEARLY
WEEKLY
X
Check if ball valve is open on tank Check oil level in tank and refill if necessary Check on ground for overnight leaks
Check cylinders, pump control valve and system for leaks. Repair/replace if required.
Replace hydraulic filter * Drain oil, clean strainer and refill Check pressure Open hopper trap on right hand side
1.4.3
1.4.10
1.4.9
1.1.8
Hydraulic cylinders and cylinder pins, hoses, pipes and hydraulic connections, wear of floor and side of hopper.
Check for corrosion
EVERY 2
MONTHS
DAILY
Clean under and behind the packer blade
4.2.1
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○ ○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○ ○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
X X
X
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○ ○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○ ○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○ ○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
X
X
X
X
X
X
X