OPTIMIZER
TM
54
1. The packer wear plates have too
much wear.
3.1 TROUBLESHOOTING TABLE (continued)
PROBLEMS POSSIBLE CAUSES REMEDY
Excessive vertical or as sideway
of the packer blade.
1. Inspect the wear plates as
movement (sec 1.0) and
replaced if necessary.
2. The faulty selenoid must be
replaced.
2. Check for melted fuses.
2. Solenoid valve is faulty.
1. No electrical power reaches
the solenoid valve
1. Check for power source on the
solenoid valve (located in the
console).
2. Adjust or replace the limit switch.
1. Open the tailgate completly.1. The tailgate is not fully opened.
2. Tailgate “fully opened” limit
switch faulty or out of adjustment.
Packer blade is not working when
pressing the green button
Packer blade will not push the
load out.
1. Fix problem if any prior to lift the
red(stop) push button.
1. The red (stop) push button
wasvolontary or accidentaly
depressed.
2. Hopper door open
Pump will not engage, the packer
will not work.
To Next Page
Loading...
