Mobility kit
If you have purchased a mobility kit, now is the ideal time to fit it as the table
has not been fitted to the machine and the bandsaw is lighter, but the mobility
kit can be fitted later if you require it.
Mobility kit assembly procedure
1. Rest the bandsaw on a 2" X 4" wood or something similar.
2. Fit the shaft through the base of the bandsaw.
3. Fit the wheels, washers and split pins as shown on both sides of the base.
4. Fit the front bracket as shown. Note the number of holes in the bracket
may vary depending on the bracket supplied.
Note: The mobility kit may be supplied with 2 spacers that are used to
adapt it for other machines. Discard the spacers.
Note: Leveling bolts and a flat head counter sunk screw are provided
with the machine. If you are fitting a mobility kit you will not need the
bolts/screw. Discard them.
To Next Page
Loading...
