Vertical adjustment
Mark the bolts so that you have a reference to their original position. If you get
confused, you can go back to the original position.
Correction for fig. A
Loosen the shaft clamp screw that is positioned
in the center of the 4 adjusting bolts. Loosen the
top vertical bolt ¼ turn and tighten the bottom
bolt.
Do not try to do big adjustments, but rather
complete several small adjustments.
Turn the wheel by hand and notice the change in
position of the blade on the lower wheel.
Repeat the adjustment procedure if required.
Once the adjustment is completed retighten the
shaft clamp screw.
Correction for fig. B
The procedure is the same as for Fig. A, but loosen the bottom bolt and tighten
the top bolt.
To Next Page
Loading...
