Adjusting the fence
Method 1
1. Make a straight pencil line on the edge of a board.
2. Feed the wood into the blade cutting next to the pencil mark. If the blade
is drifting, you will have to compensate by angling the wood to keep the
cut straight.
3. Stop the cut in the middle of the wood and mark [pencil] the angle on the
table. This is the angle of drift and you will have to set the fence to the
pencil line.
4. To adjust the fence, loosen the clamp bolts that attach it to the cast-iron
bracket. Move the fence so that it lines up with the pencil mark on the
table and retighten the clamp screws.
To Next Page
Loading...
