45
SPECIAL PROGRAMS
25 • WASH KIT
LIQUID DETERGENTS
25.3 • CARTRIDGE/CONTAINER
REPLACEMENT CALFREE
DESCALER
If when calling the automatic wash
procedure, SOFT [SC], HARD [HC], HARD
PLUS [HPC], or HARD PLUS ECO [HPC
ECO], [SCA] appears flashing in the
bottom display, check the descaler level by
opening the oven door and the door under
the oven cooking chamber and checking
the amount of descaler in the cartridge.
If the cartridge/container is empty, replace
it. Otherwise press 15 START/STOP for the
wash procedure.
The CALFREE descaler cartridge has a
GREEN cap.
COUNTERTOP MODELS - CARTRIDGE
REPLACEMENT:
Unscrew the cap from the empty cartridge
and remove it.
Put the new cartridge in the oven housing.
IMPORTANT: Wait for the liquid to
stabilize before opening the cap.
Remove the cap from the new cartridge
and insert the hose with the GREEN cap,
making sure the hose is turned to the front
of the cartridge, and close the cap tightly.
FLOOR MODELS - REPLACING THE
CONTAINER:
Unscrew the cap from the empty container
and remove it.
Put the new container in its place.
IMPORTANT: Wait for the liquid to
stabilize before opening the cap.
Remove the cap from the container and
insert the hose with the GREEN cap,
making sure it reaches the bottom of the
container, and close the cap tightly.
Press the 10 knob for three seconds (until
the message [SCA] disappears from the
bottom display) to reset the descaler level
to the maximum.
Press the 15 START/Stop button to start the
wash.
To Next Page
Loading...