46
SPECIAL PROGRAMS
25.4 • SOLID CLEAN DETERGENT
CREATION
When calling up the SOFT [SC], HARD
[HC], or HARD PLUS [HPC] automatic
washing procedure, if the lower display
shows the flashing message [dEt], the
creation of the SOLID CLEAN detergent
must be performed.
Proceed as follows:
Select the automatic wash desired and
press START/STOP.
The heating/cooling procedure for the oven
chamber is performed.
Follow the instructions on the lower display:
[Fd1] Remove the cap from the SOLID CLEAN
drawer
[Fd2] Insert the SOLID CLEAN container and
press the START/STOP key
[Fd3] Waiting water loading in progress
[Fd4] Waiting recirculation in progress
[Fd5] Remove the SOLID CLEAN container
[Fd6] Did the container empty?
Select “Yes” [Y] pressing the “Core probe”
key or “No” [n] pressing the “Fast Dry” key
twice.
[Fd7] Thoroughly clean the cap housing and the
cap and replace the cap.
If there is an error in the detergent creation
procedure, the error message [Err]
appears on the upper display and the
procedure is interrupted. Press START/
STOP to restart the procedure.
If the error persists, note the error code
and contact customer service.
NOTE: The wash is done as needed
between phases [Fd2] and [Fd5].
When washing is complete, the displays
show the procedure has ended (example:
[HPC] [End] ).
25 • WASH KIT
SOLID DETERGENTS
To Next Page
Loading...