47
SPECIAL PROGRAMS
25.5 • SOLID CAL DESCALER CREATION
When calling up the washing procedure,
if the lower display shows the flashing
message [SCA], the creation of the SOLID
CAL descaler must be performed.
Proceed as follows:
Select the wash and press START/STOP.
The heating/cooling procedure for the oven
chamber is performed.
Follow the instructions on the lower display:
[FC1] Remove the cap from the SOLID CAL
drawer
[FC2] Insert the SOLID CAL container and press
the START/STOP key
[FC3] Waiting water loading in progress
[FC4] Waiting recirculation in progress
[FC5] Remove the SOLID CAL container
[FC6] Did the container empty?
Select “Yes” [Y] pressing the “core probe”
key or “No” [n] pressing the “Fast Dry” key
twice.
[FC7] Thoroughly clean the cap housing and the
cap and replace the cap.
If there is an error in the descaler creation
procedure, the error message [Err]
appears on the upper display and the
procedure is interrupted. Press START/
STOP to restart the procedure.
If the error persists, note the error code
and contact customer service.
NOTE: The wash is done as needed
between phases [FC2] and [FC5].
When washing is complete, the displays
show the procedure has ended (example:
[HPC] [End] ).
25 • WASH KIT
SOLID DETERGENTS
To Next Page
Loading...