21
5 Commissioning
5 Commissioning
5.1 Safety
5.1.1 Safety When Putting the Device Into Operation
WARNING!
Observe the safety instructions from chapter 2.
Disregard for these safety instructions can result in severe injuries or significant physical dam-
age.
DANGER!
Danger if shock protection is not provided
There is a risk of death or very serious injury from electric shock.
When installing the electrical accessories, do everything necessary to provide shock pro-
tection.
NOTICE
Exceeding the maximum permissible operating temperature
Ensure that the maximum permitted operating temperature (refer to this in table in chapter11.1
Technical Data), particularly due to radiant heat, is not exceeded at the installation location.
Take action to ensure sufficient cooling.
NOTICE
Laying of cables
Warning to avoid damage to property
Lay the connecting cable including its extension apart from the mains and control cables
(don't lay them parallel to each other).
Avoid laying cables near the following components:
- ignition cables
- ignition transformer and electric motors
- contactors resp. switches and frequency transformers, which switch high inductive or ca-
pacitive loads.
Although the device exceeds the requirements of the applicable EMC standards, in some
cases by a considerable amount, proper wiring is the prerequisite for ensuring that the de-
vice and thus the entire plant operates without problems in all cases.
To Next Page
Loading...