Lamtec FMS Series User Manual

Appendix Replacing a Servomotor
Replacing a Potentiometer
Replacing a While replacing a servomotor with LAMTEC precalibration with another
Servomotor with servomotor with LAMTEC precalibration, normally there are no further
LAMTEC Precalibration justifcations necessary.
____________________________________________________________________
A servomotor with precalibration is calibrated ex works, that the angular
degrees 0° - 90° at every motor are equal to the potentiometer values.
Therfore the replacement of these motors causes no deviation between the
calibrated curve in FMS and the associated damper position.
____________________________________________________________________
You may not change any settings or tamper at a motor with LAMTEC
precalibration. Especially you may not adjust a position switch or the
adjustment of the potentiometer. The precalibration will be lost in this case.
The firing has to be readjusted as the case may be.
____________________________________________________________________
!
i
124

Lamtec FMS Series Specifications

General

Brand	Lamtec
Model	FMS Series
Category	Controller
Language	English