62
8 Options
8.2.3 Settings
Only in access level 2 (Service)
In the MAIN MENU, select to make set-
tings.
In SETTINGS select for digital outputs.
In DIGITAL OUTPUTS select 1, 2, 3, or 4 to
allocate the desired trigger to the respective
digital output.
Warning
locked fault
Calibration
Maintenance
Limit value
Limit value 1, digital output 1 only
Limit value 2, digital output 2 only
Limit value 3, digital output 3 only
Limit value 4, digital output 4 only
CO edge signal
Operating current (relay switches
when the trigger is active)
Closed-circuit current (relay switches
when the trigger is not active)
To Next Page
Loading...
