Lamtec LT3 - HART Commands and DIP Switch Settings; Field Bus Module for PROFIBUS PBM100; DIP Switch 8

67
8 Options
8.4.2 HART Commands and DIP Switch Settings
See separate documentation.
8.5 Field Bus Module for PROFIBUS PBM100
The burner control system communicates via LAMTEC SYSTEM BUS (LSB) with its modules
consistently. PROFIBUS module PBM100 integrates LAMTEC burner control system into field
bus environment (PROFIBUS). PBM100 listens for different, measured process values on
LSB, processes these signals and transfers them to field bus.
Setting of LSB address not necessary.
8.5.1 DIP Switch
Use DIP switches to configure settings of PBM100.
Functions of DIP switches
LSB family is set by DIP switch 8-9.
DIP switches 1 - 7
1 Binary coded PROFIBUS DP address
Switch no. 1 = bit 6
Switch no. 7 = bit 0
0
Example:
DIP switch 8 DIP switch 9 LSB family
001
012
103
114
DIP switch 10
0 CAN terminal resistance inactive
1 CAN terminal resistance active