Lamtec LT3 - Analogue Outputs; Replacing a Probe; Display; Limit Values

47
5 Maintenance
5.2.3 Analogue Outputs
In "SETTINGS", select for analogue outputs (see Chapter 8.1.3 Conversion of the Output
Range via the User Interface).
5.2.4 Replacing a Probe
5.2.5 Display
5.2.6 Limit Values
Probe replacement:
A minimum of access level 1 is required for
triggering.
(See Chapter 5.2.4 Replacing a Probe.)
Display (no access level is required):
Brightness
Contrast
Time in seconds until the
background lighting is shut OFF
Switch from °C to °F and vice versa
Limit values
Proceed with the key.