70
8 Options
Bit encoding of CO/O
2
actual value status
Bit encoding of LT3(F) device status
Digital module 8 31 30 29 28
Digital module 9 35 34 33 32
Digital module 10 39 38 37 36
Digital module 11 43 42 41 40
Digital module 12 47 46 45 44
Digital module 13 51 50 49 48
Digital module 14 55 54 53 52
Digital module 15 59 58 57 56
Digital module 16 63 62 61 60
Active (bit encoding) Explanation
0x0001 CO edge not triggered
0x0002 CO edge triggered/undershot
0x0001/0x0002
Not set
Edge signal not determined by sending device
0x0200 Underrun
0x0400 Overrun
0x0800 Maintenance mode
0x1000 Replacement value is sent
0x2000 Warning of measured value
0x4000 Fault of measured value
0x8000 Measured valid
Active (bit encoding) Explanation
0x0001 Measurement
0x0002 Heating up
0x0003 Calibration
0x0004 ... 0x0100 Not assigned, invalid
0x2000 Maintenance
0x4000 Warning
0x8000 Fault
LSB module no. LSB family
1 2 3 4 BT300 support
Until Release 3.3
To Next Page
Loading...
Need help?
General
