PRE-INSTALLATION CHECKLIST
BEFORE GETTING STARTED
Each unit is tested under operating conditions and is thoroughly inspected before
shipment. At the time of shipment, the carrier accepts responsibility for the unit. Upon
receiving the unit, carefully inspect the carton for visible damage. If damage exists, have
the carrier note the damage on the freight bill and le a claim with carrier. Responsibility for
damage to the dispenser lies with the carrier.
4
TOOLS & ACCESSORIES
CO2 Regulator Set Beverage Tubing
CO2 Supply Water Booster (if necessary)
Remote System Oetiker Clamps/Fittings
Wrenches Slotted Screwdriver
Tubing Cutters Drill
CONSIDER LOCATION OF THE FOLLOWING PRIOR TO INSTALL
Water supply lines Is the countertop at least 1 inch thick?
Grounded electrical outlet. Drain
Is there enough space to install the dispenser and the junction box?
BIB SYSTEM
BIB Rack BIB Regulator Set
BIB Connectors - verify correct amount for syrup lineup
BIB Syrup Boxes Remote Cooling/Carbonation System
To Next Page
Loading...
