15: Command Reference
SLC™ 8000 Advanced Console Manager User Guide 385
Description
Set default & fail-over gateways (the fail-over gateway is used if an IP address usually accessible
through the default gateway fails to return 1 or more pings), and configure settings for supported
fail-over devices.
set network host
Syntax
set network host <Hostname> [domain <Domain Name>]
Description
Sets the SLC host name and domain name.
set network fqdnlist
Syntax
set network fqdnlist <1-15> ipaddr <IP Address> fqdn <hostname>
Description
Updates the local hosts table for DNS lookup of FQDNs.
set network port
Syntax
set network port <1|2> <parameters>
Parameters
state <dhcp|bootp|static|disable> [ipaddr <IP Address> mask <Mask>]
ipv6addr <IPv6 Address/Prefix>
mode <auto|10mbit-half|100mbit-half|10mbit-full|100mbit-full|
1000mbit-full>
mtu <Maximum Transmission Unit>
set network ipv6 <enable|disable>
Description
Displays DNS settings.
show network dns
Syntax
show network dns
To Next Page
Loading...
