LT-3100 User & Installation Manual Rev. 1.06 Web server
Lars Thrane A/S www.thrane.eu Page 130 of 155
Software update
Carefully read the software release note, provided by Lars Thrane A/S, before software updating the LT-
3100 system.
Access the web server of the LT-3100 system, by following the instructions in Accessing the built-in web
server on page 101. Select the ‘Software update’ web page and click the ‘Choose File’ button to select the
LT-3100 system file, which must be uploaded to the system. The software image has the following filename
(example): LT-3100-v1.10R-0005.lti - the software image and release documentation will be available on
the official company website: https://www.thrane.eu, under the specific product or in the Partner Area.
Click the ‘Upload’ button to start the upload of the new software image. The upload and installation of the
software image will take a few minutes. Progress indication bars can be monitored on the Software update
webpage, while the software update is on-going. The LT-3100 system will reboot once the software image
is installed safely in all units.
NOTE: The LT-3110 Control Unit and LT-3130 Antenna Unit, must be operated with the same
software version. The software update will happen automatically, if the control unit
identifies that the software version in the antenna is different. Check or verify the web
server Dashboard for software versions in each of the LT-3100 system units, see Dashboard
on page 102.
IMPORTANT: Do not remove power from the control unit while the software update is on-going. Also, do
not disconnect the antenna cable between the control unit and the antenna unit, while the
software update is on-going.
IMPORTANT: The Advanced Settings shall not be used under normal circumstances. Do not use this
function unless specifically instructed by Lars Thrane A/S or by the Lars Thrane A/S certified
partner.
To Next Page
Loading...
Need help?
General
