1 1
o to avoid disturbing of other people with noise, exhaust fumes or ejected
flying particles (at windy weather),
o to keep traffic rules and local regulations when going or working on or
nearby public roads,
o to turn the machine off if the discharge duct is clogged.
o Clean the duct at standstill only. For cleaning use only suitable hooks or
bars to release pressed materials. After repeated putting the chipper into
operation let the machine run idle in the chipping mode to empty the whole
discharge ducting. If proper cleaning is required then take always the
switch key out of ignition before removing hoods.
o While working, never lean over the loading chute and never push wooden
materials with your hand or foot only. Use always a wooden stock or a bar
to push materials between the loading rolls.
o While working, wear always personal protective aids - protecting shield or
goggles, protective gloves, working shoes and working cloth properly
buttoned. Avoid wearing free parts, such as ties, scarves and shawls, belts
etc. In case of longer hairs use always a proper head piece. Otherwise,
such a person is not allowed to operate this machine.
o In case of two attendants it is necessary to make simple signals clear
before working and to appoint one who will manage the work.
o If any object, not allowed to be chipped, falls down into the loading chute,
do not try to pull it out with your hand. It is hazardous for your health and
operational safety. Turn always the machine off.
- Keep traffic lights and work safety symbols in proper order.
- Check materials to be loaded and remove all undesirable objects. If you
see such particles in ejected chips stop working immediately.
- This manual describes problems and faults which could occur at work and
which may be remedied by an instructed person. In case of other problems
and faults do not hesitate and contact the manufacturer. He is always
ready to help you.
- Never do any technical changes or any actions which are neither given in
this manual nor allowed by the manufacturer. The machine, not correctly
installed or adjusted, may run without problems now but in the future it
could damage any of important parts. Pay regular attention to all joints and
bolts. Keep them properly tightened.
- Do not put any objects or tools on the machine.
- The manufacturer does not bear responsibility for any damages or injures
to the third persons or to other equipment resulted from disobedience to
instructions given in this manual.
- When handing the machine over to another person make sure if all
controls, guards and other safety elements are complete.
To Next Page
Loading...
