1 2
- Do not remove guards and other safety elements. They serve for your
safety.
- Keep the given intervals for checks of bolted joints.
- Always after work clean all parts of the machine with pressure water. Pay
your attention especially to any oil spots or fuel leakage. Clean any oily
spots.
- Some parts of the machine can be hot while in operation. Avoid any
settling of flammable chipped materials on such parts or close to the fuel
tank, the hydraulic oil tank and the exhaust manifold. Stop working if such
deposits exceed 1 mm.
- Any servicing can be done only if the machine was put out of operation
and its battery was disconnected.
- Avoid any random start - disconnect the plus pole of the battery.
- Fill up the fuel tank before working and only if the machine is turned off. To
fill up the fuel tank use always a proper filling funnel with an extension.
- Do not fill the fuel tank while the engine is hot or still running.
- Do not start if some fuel has been spilled.
- Do not use petrol as a cleaning agent.
- Keep open fire away while filling the tank.
- Keep the machine beyond reach of open fire.
- Some parts of the machine run warm, such as hydraulic elements. Do not
touch them when the engine is still running or having been just stopped.
- Do not let the engine running in high speed unreasonably.
- Do not change the engine adjustment, especially its speed regulator.
- Be careful at battery handling.
- Warning! The battery contains sulphuric acid that could cause burns.
Rinse all stained spots with water properly and wash them with soap.
- The battery must be always installed and fixed properly in its holders.
- Do not start the machine in confined or ill-ventilated spaces.
- Do not use the machine under conditions of low visibility, especially at
foggy weather on public roads.
- Do not use the machine without prior reading this manual.
- Do not carry out any repairs that are specified for authorised services only.
- Do not carry out any repair where its solution exceeds your experiences.
- It is strictly forbidden to work with damaged chipping device (out-of-
balance, vibrations while running).
- While working, the chipper should be blocked against unwilling motion (pin
coupled).
- While coupling the chipper, do not stand between its towing bar and a
towing vehicle. Do not stand behind a towing vehicle while backing. Ask
other person to help you at coupling.
To Next Page
Loading...
