Lattec Herd Navigator - Start Cleaning from si Menu

To Next Page

To Previous Page

April 8, 2011 HN FAQ Memo, Version 3.0 Page 19 of 108

3.1.4 Start Cleaning from SI menu :

First get acces to the menu in SI… this can be trough AC via Ethernet, or direct whit RS-232 cable to the

circuit board (baud rate 38400).

If not in the menu, press M

Press 1, for Maintenance menu

Press 2, for AI Cip

Press Enter to activate CIP, and the SI starts to fill Clean and Rinse whit water, and heat it up. In about 20-25min, the

CIP is started.