Lattec Herd Navigator - Update Orders in AC; HN Service Controller

April 8, 2011 HN FAQ Memo, Version 2.0 Page 81 of 108
5.1.3 Update orders in AC / HN service controller.
If the AC has been updated or replaced the orders send from the DSM has to be updated. This is
done in the HN service controller program.
The DSM Service Controller program is started from the „Start‟ folder. A „green cow‟ is seen in
the taskbar if the HerdNavigator Services are running and a „red cow‟ is seen if it is not.
HerdNavigator Local: The DSM Service Controller controls the main DSM Service.
HerdNavigator Central: The DSM Service Controller controls the main DSM Service and the
DHIADispatcher service.
Right click the cow icon in the taskbar and select „Show‟ to show the application. If not opened
at once use the „ALT Tab‟ keys to select the application.
Service started. Service stopped.
Follow these 3 steps to update orders in AC:
1: Stop Herd Navigator DSM: