April 8, 2011 HN FAQ Memo, Version 3.0 Page 3 of 108
3.4 Sampler. ......................................................................................................................................... 64
3.4.1 Recalibration of sampler transfer time. ...................................................................................... 64
4 INFO: ..................................................................................................................................................... 65
4.1 Menu overview for the Sample Intake, (SI) ................................................................................... 65
4.2 Menu overview for the Analyser instrument (AI) ......................................................................... 67
4.3 Menu overview for the Analysis controller (AC) .......................................................................... 72
4.4 Connecting AI to the drain with pn:60045416............................................................................... 74
4.5 Tube Connections on Sampler version II ....................................................................................... 75
4.6 Replacing the CIP box in the Parlour/VMS Sample Intake (upgrade). ......................................... 77
5 Appendices: ............................................................................................................................................ 79
5.1 AC .................................................................................................................................................. 79
5.1.1 Remote connection to AI or SI trough AC whit ethernet : ........................................................ 79
5.1.2 AC basis settings IP address (Reset / New instalation) (VMS / Parlour) ................................. 80
5.1.3 Update orders in AC / HN service controller. ............................................................................ 81
5.2 Updating firmware in HN Units..................................................................................................... 83
5.2.1 Tools Needed : ........................................................................................................................... 83
5.2.2 Preparation and Connection to the Unit ..................................................................................... 83
5.2.3 Programming the Unit ................................................................................................................ 85
5.3 Updating the AC, AI, or SI boards with new version of the bootloader. ....................................... 89
5.4 Sampler programming guide :........................................................................................................ 92
5.4.1 Decimal - hexadecimal conversion table ................................................................................... 98
5.5 Updating FPGA software on HN2 AI ............................................................................................ 99
5.6 HN2 AI startup settings................................................................................................................ 102
5.6.1 Step 1 : Connect AI to the Ethernet. ........................................................................................ 102
5.6.2 Step 2: Entering the rest of the Ethernet settings in the AI configuration. .............................. 103
5.6.3 Step 3 : Use the AC‟s Web interface to setup AC to use HN-2 AI. ........................................ 105
5.6.4 Step 4 : Setup the Alcom address for the AI in Sample Intake to same address as the AC..... 108
To Next Page
Loading...