Lauda RP 855 - Menu Structure Contact Module (Master)

Proline Low-temperature Thermostats
YACE0072 / 21.08.07 Interfaces - Modules 113
8.5.3 Menu structure contact module (Master)
All existing dialogue boxes are illustrated. The Master unit however masks out commands, which cannot
be executed.
1%21
Actual bath temperature
or actual value of
external temperature
LMnet Configure
modules
ch&-- Configure
contact module
E /EE
Input switched off
TDp : Display module software
version
ch0 X: Display status on
Input 1
ch1 X: Display status on
Input 2
ch2 X: Display status on
Input 3
cm0 X: Display status on
Output 1
cm1 X: Display status on
Output 2
cm2 X: Display status on
Output 3
T13 : Display 24V supply
voltage
Rlp^G : Module serial number
Places 1-5
Dlc
Quit calibration level
Rlp^K : Module serial number
Places 6-10
RgmYW
Display level
ch1--
Set Input 2
cm0--
Set Output 1
ch0--
Set Input 1
cDE Restore
factory settings
Dlc
Quit menu
ch2--
Set Input 3
cm1--
Set Output 2
cm2--
Set Output 3
E Bml Control type on this
input activated
E @K@ Alarm function on this
input activated
E Rra Stand-by function on
this input activated 
E Op5 Programmer function
on this input activated
E r1B Temperature alternat'g
mode on this input activated
Select0, DR, D@ or DO as
control source
E XXX
Select input function
Dlc
Quit settings level
/ODl only for alternat. mode:
setpt. temp. on 'contact open'
BK/RD only for alt. mode:
setpt temp on 'contact closed'
/ODl only for control type:
type on 'contact open'
BK/RD only for control type:
type on 'contact closed'
E /EE
Output switched off
E E0K Refill bath liquid on
this output activated
E ch@
Fault diagnosis mode
E Rra Stand-by function on
this output activated
E VWh Temperature window
on this output activated
E Op5 Programmer status on
this output activated
E XXX
Select output function
Dlc
Quit settings level
c XXX only when diagnosis
func. selected for ouput
p 0</ only when window
function is active : set temp.
window
c @KK All alarms,
warnings and faults
c KDU
Low level alarms
c /Tr
Overtempeature alarm
c Dpp
All fault messages
 See safety instruction
Ì 7.7.3