Lauda RP 855 - Basic Settings and Branching to Submenus (Master)

Proline Low-temperature Thermostats
36 Starting up YACE0072 / 21.08.07
7.6.1 Basic settings and branching to submenus (Master)
Master; Main level

2 dots in the display, e.g. LMDkt, indicate that a submenu follows.
3 dots in the display, e.g.
LMnet, indicate that a module submenu follows.
Bath temperature
1%21
°C
Pump power 1-8/Standby.0
Os 7
°C
Setpoint
RDr
°C
Control Intern / Extern
Bml 0
°C
Further settings
LMDkt
°C
Configure modules
LMnet
°C
End
Dlc
°C
⇒ Section 7.6.2
⇒ Section 7.6.3
Display flashes. Set setpoint
with or . Display
is accepted after 4 sec. or
proceed immediately
with the key:
Control parameters,
setpoint resolution,
setpoint-source input,
calibration, etc.
Protection system,
Command, cooling system,
analog and RS232 digital
module, etc.
External temperature
1%/1
°C
EXT
Display flashes. Set value
with or . . Display
is accepted after 4 sec.
or proceeds immediately
with the key:
⇒ Section 7.7.3
⇒ Section 7.7.4
⇒ Section 7.7.1